Disco Bangle
Thread Spool Necklace
Cord & Tape Necklace
YOU WILL NEED:
silver cord
neon tape
Paper Clip Necklace
YOU WILL NEED:
paper clips of desired color and size (I used large and small gold
paper clips)
wire cutters
1. Cut thin strips of tape and wrap tape around the cord every 5
inches. 2. Tie the ends of the cord together.
Disco Bangle
YOU WILL NEED:
can (I found that canned bamboo shoots worked the best for
this craft)
Mardi Gras beads
can opener (the kind that opens the can without creating
sharp edges)
scissors
hot glue gun
1. With wire cutters, cut paper clips directly adjacent to either
terminal end, creating a large outer loop or a small inner loop.
2. To create the desired length of chain, connect cut paper
clip loops by simply sliding them together. 3. Layer chains of
different lengths for a multi-dimensional tiered effect.
1. Use can opener to remove top and bottom of can. 2. Remove
the can’s label and clean the can thoroughly. Allow it to dry. 3.
Cut each strand of Mardi Gras beads once to create single long
strand. 4. Wrap beads around the can, securing with hot glue
on the inside of the can, trimming and gluing as necessary.
5. Continue wrapping strands around the can until it’s entirely
covered and bangle is complete.
Ribbon Necklace
YOU WILL NEED:
metallic ribbon
measuring tape
scissors
hot glue gun
1⁄ 8 -inch hole punch or screw punch
2 jump rings
small pliers
chain of desired length
1. Measure out 3 lengths of ribbon— 24 inches, 36 inches, and
48 inches. 2. Fold each length in half and crease to find middle.
